acciaio

Hello, I am carrying out a project for an engineering examination; performing the calculations on a circular section element, I get an ideal voltage of about 980 mpa. I am therefore looking for a steel for my bar, 80 mm circular section, with at least one yield of 1500 mpa as then I will have to...

Good evening! I am a technical workshop designer, at a metal carpentry. I wanted to address this forum to confront me with some other designer or designer who uses autodesk advance steel software like me! Unfortunately I am a self-taught software, as my company did not want to invest in my...

Good morning, everyone.I take care of setting up photo exhibitions in the outside and recently I thought of designing a new structure. Unfortunately I got stuck on a problem and I hope someone can give me some useful suggestions (I should have done mechanical engineering and not architecture)...

Hello I am a student of architecture and would be very grateful if you would help me with this question: I would have a structural mesh of type 7m x 3.5 m and my intention would be to use a dry assembly (steel) for all floors of the residence I wanted to know if in principle with such measures...

Good morning! I ask the whole forum how I can calculate the molding force to produce steel flanges through crank presses. I would need a quick formula knowing the geometry and material of the piece to produce. the result must lead me to choose one type of car compared to another. are you aware...

hi to all, I am new to the forum and especially the design with revit. I have come across a problem regarding the creation of a steel loft and especially in the creation of a single with Greek plate.:frown: Would someone help me?thank you so much:redface: