albero

Hi, I'm a spacecraft engineering student and I'm new on the forum. I am preparing the industrial technical drawing exam and if possible I would need help on an exercise, which I attached in the post. Attached I also entered as for now I am carrying out the exercise, performing the first 4...

Good morning to all, I apologize for disturbing, I would need some tips regarding the geometric tolerances to put on a shaft for wheel drive of a chariot (low number of turns, high torque). the shaft is profiled for coupling with the gearbox, with two bearing surfaces type 22216e and at the...

Good morning to all, I am a neophyte of solidworks, I use it for a few months and only now I'm finding a problem that I can't solve. I'm working on a part file. I created a part formed by many bodies, at the moment they are more than 40. this because I had to create a complex set of very small...

Good evening to all, I am a university student of mechanical engineering. as part of a project I must carry out a fem analysis on a small motor shaft (diameter 8 mm). I wanted to know what the correct constraints are to be applied for static analysis. in fact I tried to bind the tree in various...

good morning to all and compliments for the forum always very useful. I have to perform an analysis (with mechanical self-desk) on a rotational shaft at 1500 rpm to which a rotor of a turbine is connected which puts it in rotation. I imported the 3d model into the mechanical modeling software...

It is the first time I open a discussion in this forum, so I hope I do not miss the section and do not break various rules of the regulation, in which case I apologize earlier. the question that I ask you is the following: in the middle shaft of a two-stage reduction gearbox with parallel axes...

Good evening, I am designing a tree whose constraints are constituted left by a grooved profile to non-sliding evolving from which the couple enters and right by a ball bearing. the ratio between primitive radius and grooved profile length is 1.3. in static analysis, considering maybe a couple...

Hello is it possible to have the cat tree that develops like "timeline" and not enclosing the features in the body? all the logic of the passages and rebuilding it is practically impossible! ! !

Hi. I'm trying to figure out what standard the tree can belong to with 13 teeth, the outer diameter I measured with a 20th-gauge is 28.7 mm . the tree is built to be used in a grip of force of a tractor. Thank you!