Good morning, everyone. I own a burgman 650 and I want to change the rear shock absorbers.
Original shock absorbers are attached to the fork via a bolt m10, which reports a "7" molded on the headthe shock absorber is mounted in this way:therefore -from what I saw googlando- is subjected to...
Bye to all,
I write to you as I would need an expert opinion about threaded links that can be shaped with pro/mechanica.
I tried to simulate a connection between two plates using:
- cylindrical beam (with screw section) bound with rigid constraints between 1) portion of curve and threaded...
Hello everyone,
I am a material engineering student and I am following a very basic invetor course (5 cfu) so I apologize if I use an untechnical language.
I'm designing an ironing engine and I'm practically finished modeling all the pieces and assembling them. at this point I have to insert...
