cilindro

good morning to all, has it been implemented that you know in the last versions a sort of feature rototranslation that allows me to move both axial and rotary around a board? In essence I have several repetitive works to perform on a cylinder, which must have both an axial step and a precise...

Good morning to all, my name is luca and I am a mechanical engineering student struggling with the three-year thesis in fluid dynamics. I was assigned the classic flow problem on a 2d cylinder, which so far gave results too far from literature due to mesh limited to 512000 cells.to overcome the...

Hello everyone, my name is luca and I am a mechanical engineering student struggling with the three-year thesis. I chose to ask for it experimental to fluiddynamics and I was assigned the classic flow problem on a cylinder to analyze with software fluent students version, with mesh limited to...

Hello everyone, I am new in the forum and this is my first discussion. in short: we are designing a clamping equipment for structural components in c45 1.1191. In the first phase I need to use hydraulic cylinders for positioning on fixed side feedback and then carry out the seal with magnetic...

Good morning to all, I tried to search on the forum but I found nothing. This is my problem: how do I in solidworks limit the stroke of a pneumatic cylinder from all closed to all open? In practice if I fix the base and pull the stem now I can't put the race for example of 50 mm. Thank you for...

Hello everyone, it's my first post here, I'm pressing that I'm a user with the very first weapons. I come to this point: I have to make a simulation of the thermo-mechanical stress of two coaxial cylinders, the internal one at a certain temperature t greater than the external one. Could you tell...