• This forum is the machine-generated translation of www.cad3d.it/forum1 - the Italian design community. Several terms are not translated correctly.

cuscinetti

  1. dynamic load coefficient bearings arranged to x

    Good morning. I should create a gearbox which consists, in a synthetic way, of two trees supported both on one side by a radial ball bearing and on the other by a pair of x-shaped oblique ball bearings (see attached photo). I had already designed to dimensional the duration of bearings, however...
  2. mechanical design of a reducer

    hello to all, I am a student of mechanical ing and attended polytechnic, I would like a comparison regarding the correct representation in 2d of the components with the regulations of the technical representation of this mechanical assembly. the design represents a reducer of a straw
  3. locking of mixed bearings (obliques or conical rollers)

    hello to all, I am a mechanical student at the first year who is attending the drawing course of machines. I need a tip about locking the mixed bearings. I have not been able to understand how the bearings must be blocked according to the type of assembly you have (e.g. x or o). would you kindly...
  4. fat loss from bearings

    hello to everyone, I wanted to ask you what could be due to the fat spill from a bearing. in my case the bearing is a radial to a crown of balls with double shielding steel (2z). It is cast on a pin so the inner ring is still and rotates the outside. the exit takes place near between the shield...
  5. problem bearing kisssoft

    Good morning to all, I have a problem with kisssoft or continue to give me warnings on the bearings, that is: "the minimum bearing load is not reached!" I'm trying anything that comes to my mind to solve the problem, but that's what's going on. I attach warning screens I thank you and wish you...
  6. mounting and clamping bearings

    Hello, I am a new user, I would need your help to know if my bearing design of my gearbox is done well. I had designed the bearings so that the one above is a hinge and the one below a cart, but I'm not sure that I mounted them in the right way. Could you give me some advice or maybe some files...
  7. choice of bearing seat processing tolerances

    Good morning to all, I am new (written for years but this is the first time I start a discussion), I am here to ask you a hand for the design that I am currently following, it is a blower with 2-stroke engine. the application has a motor that turns at 7000 rpm and reaches a temperature of 120...
  8. axial roller bearings

    on these types of bearing the radial game is very important and repercussions on the axial one. At times, double crown roller bearings can be mounted and the axial game after assembly does not exist or is reduced. This is wrong. For example, an internal diameter bearing 160 could have an axial...
  9. cross roller bearings

    Good morning. I am thinking of the use of a cross roller bearing on a tree, replacing two radial ball bearings, with the aim of obtaining reduction of tree length and greater rigidity. "These bearings absorb bidirectional axial loads and radial loads, tipping moments and any load combination in...

Forum statistics

Threads
44,997
Messages
339,767
Members
4
Latest member
ibt

Members online

No members online now.
Back
Top