impostazioni

Hello everyone! Forgive the question that perhaps for many will be trivial, but how do I inherit the colors of the surfaces on catia v5? I'd like to do what this guy does in this video: I would like to maintain the color of each single surface, both after the union and the cutting of the solid...

Bye to all, I ask you help with a problem about catia v5r19 that I have for some time: the almost systematic crash of catia when loading (or looking) large medium sized files (from 200-250 mb up). I don't know, and here I ask you for help, if these crashes depend on: - lack of memory? (memo...

Hello everyone, for reasons of work I use solid edge for over two months now but I have never understood whether there is the possibility to open a set already activated instead of manually activating it at every opening of the file. If someone knows a way, I would really help. Good evening...

Good morning, everyone, I'm jusy and I have a little problem and I hope you can help me. for a few years I have dealt with chains of tolerances, receiving the necessary inputs to execute the calculation. Now I'd like to try to set geometric tolerances, but I'm not sure what I'm doing and I hope...

is it possible to create a correspondence between the square of the millimeter card and the design unit? Do you have to set something at the beginning of the drawing or is it something that is set in print? are there in general initial settings to give to d a drawing during creation? attached...