Good morning to all,
I ask your help to convert a solid part with a crushed fold in sheet metal.
as design software use I create 8.0.8.0
I attach an image to make the idea better. if necessary I can also attach the .step file.
Someone can kindly give me some tips on this.
Thank you very much
Bye to all,
I got this problem, using the fold(bend) command to theok opened a window saying:
fold(bend):impossible to create fold(bend).
no corresponding face has been found.
What should I do to create the fold?
Thank you.
Bye to all,
I have recently begun to use the configurations of the parts seriously, as in some works I find it is the most logical way to work.
I found a problem in the case of sheet metal bent, and I can't figure out whether it's a 2011 sw limit or if I miss some knowledge.
the sheet should...
