quota

hi to all, I need your help to try to automate the following procedure on autocad: I need to know about each section of a gallery (even more than 1000) the distance between the train silhouette and the tunnel cap (dx and sx side) in order to be able to obtain this data in a table form. you...

Good morning to all, I have a problem with the generic quota on inventor 2020 that does not allow me to make the quota correctly. I tried to fix it but nothing to do. Does anyone know what the problem is? Thank you in advance. p.s. Attached find the screenshot of what I mean.

Bye to all, I have done a couple of researches without finding anything (both in the forum and in the help and guide) but if I am mistaken, please report it to me. I am working (with solidworks 2019 sp5) on a colleague's files, which unfortunately uses the following settings:Now, every time I...

Bye to all, I am a designer and in my technical office there is an ongoing debate, concerning the use of brackets in quotas. from what I know, inserting a dimension in brackets means that that dimension is not governed by the regime of tolerance of the cartilage, that can be fine, medium or...

Good morning, everyone. Needed to quote the distance between the two black arrows, but the altitude must indicate the distance not vertical, but parallel to the straight indicated by the red arrow, is there a way to do all this? Thank you very much to all in advance.

I'm working with autocad 2014, I entered a drawing obtained by vectorizing an old planimetry using wintopo I created a block of this design and glued it into another design, after adapting it with line I exploded the block I wanted to give a quota ( elevation) to my polylines but when I change...