riduttori

Hi, as an examination project I was required to design a gearbox assigned power and engine speed. I would like to realize the least expensive reducer possible, could you recommend the least expensive material for making it, or could you recommend the most reliable catalogs? (indicatively the...

Good morning to all, I found myself on this forum and would like to ask a question. currently to move a load between my house plans I use a modest hoist with 800kg rope of 10 mt in fabric (type car seat belts). It works fine but makes noise and then decide to request a winch. I propose a...

Hello! ! ! I am designing a cycloidal reducer that presents a cycloidal disc with 12 teeth with diameter between a tooth and its opposite of 47,5 mm, moved by an eccentric with distance from the center of 1 mm, which rotates around a crown with 13 reels of diameter 1.5 mm. I managed to make the...

Hello everyone, I know it might be a little strange question, but I'm literally freaking out to find the following books: -g. niemann, h. winter, ''elements of machines'', vol. 1, ''design and calculation of couplings, supports, trees', ed. science and technique, milano, 1983 - g. niemann, h...