hi to everyone, I have always visited the forum as a viewer, but now I have a doubt for which I cannot find answer.
I am drawing a piece, on a diameter I need to indicate a roughness of 0.8 for the first 18mm worked, while for the remaining part increases the advancement and roughness is 1.6...
hello to everyone, mark this problem that I'm finding: I am updating an existing sheet format to which I added a note with a series of neutral roughness symbols to be changed when necessary (it is a text note with symbols, not symbols united in a block). I'm going to save and it looks okay.
at...
Good evening to all are new to the forum.
I am a first-arm mechanical engineering student and today I have a doubt.
realizing a particular of a total representative a volumetric compressor, for precision the cylinder. I have come to quote the cylinder diamter in which the piston runs and to...
