Good morning guys, I'm simulating a simple compression test on a test that has 2 symmetry levels. in practice to speed the calculations I reproduced only 1/4 of the geometry and assigned the symmetry. But as you see from deformation there is something wrong. Can you tell me where I'm wrong? as...
Hi, guys, I've been kneading this morning to find a solution to my problem, unfortunately without succeeding.
I'll tell you what I want to do.
I have a parametric block that should represent an alucobond panel, and since I have 100 thousand different sizes, I would like to find a solution to...
Good morning, everyone!
I am finding the following problem: I want to mirror a solid I find myself forced to copy the body (as mirroring inside the same body I would find both solids on the drawing, thus bringing you both the mirrored object - situation that I would avoid for obvious reasons)...
Bye to all,
I have a doubt about the use of geometric tolerances of symmetry. I always use a single plan like datum (or axis in a 2d view) not to stumble into misunderstandings.
But I happen to see in some drawings even more than one datum, for example two perpendicular planes between them or...
