solido

Good evening to all, I am looking for new customers and among the various estimates asked me to analyze a project. they sent me standard parts to use for the job I have to anticipate. the problem arises because they sent me some .stl files of pieces that were developed by another designer who...

Good evening, everyone. I have to analyze with ansys fluent the fluid within a conduit consisting of 3 components made and coupled in solidworks. when I open them in ansys fluent and try to extract the volume inside I report this error: volume extract can only be used with solid bodies. I tried...

Good evening, for a project we are developing, I would need to perform a sweep cut inside a body. "the tool" that must perform the cut is not cylindrical and I would have thought of using a solid sweep cut. to theIn the example that I reported, I should take the " parallelepipedo" with the...

Hello everyone, my name is mouad and I am a mechanical designer (design of electrogen groups) use inventor 2017 I have an uneasy problem with a given engine in surface format that I can't turn into solid using the usual "join" command as I usually do this I think is caused by the various...

Bye to all, I have already presented myself in the appropriate section and now I am here to ask you with great courtesy your help. I think I'm in a situation where my ignorance doesn't make me understand where I'm wrong, I've done a lot of research on the web, but I couldn't find enough...

Hello, could someone give me a hand in converting a solid honeycomb structure to the surface?(I attach photo) I look for some advice. I would like to get a surface as I later need to perform fem analysis. Thank you.

Hello everyone, it's not much that I use rhino and I'm going crazy in an attempt to figure out how to turn a polysuperfice into a solid. I tried to take a look on the internet and on various forums, but I can't get over it. Until the polysurface is closed, it might look like a solid, but I...

Good evening to all, I have a problem with a solid to which I extracted an internal shape, I explain better: we take for example a tube made with a circle to which I subtract a circle of smaller diameter then extrude it and get a tube. my problem is that when I try to copy the tube, autocad...

Hello. I just can't create a solid from this surface. It is an offset surface of 2.5mm towards the inside and then closed with 2 "caps" at the ends.Annex. Can anyone help me? greetings