stl

Good evening to all, I am looking for new customers and among the various estimates asked me to analyze a project. they sent me standard parts to use for the job I have to anticipate. the problem arises because they sent me some .stl files of pieces that were developed by another designer who...

Good afternoon, I wanted to ask you something. I started creating a particular by opening a stl file created by a scan, then creating a link in the .ipt file. Following all the processing that create the piece, referring to the scan, I need to replace it with a new file that was sent to me. can...

good-bye, advance that I am a beginner and that I use cad only for private and not professional purposes. I just downloaded the trial version of creo 4.0 (as the old wildfire 3.0 on the new pc did not turn anymore) and after the amazingly for the amount of changes (ok, it's been over 10 years) I...

Bye to all, for my thesis work I take care of the aerodynamic analysis of a pantograph for high-speed trains. the software I use for fluid dynamic modeling is an opensource cfd called openfoam. As for geometry, I was switched to stl format as openfoam requires geometry this type of format. now...

Good morning to all, I am a student enrolled in the last year of mechanical engineering at the Milan Polytechnic. for my thesis work I am using openfoam software, an opensource cfd. the geometry object of investigation is the recent etr1000 (trade name arrowrossa 1000) that I was supplied as...

Bye to all, I have already presented myself in the appropriate section and now I am here to ask you with great courtesy your help. I think I'm in a situation where my ignorance doesn't make me understand where I'm wrong, I've done a lot of research on the web, but I couldn't find enough...

Good morning to all, I would like to use inventor 2016 student version to edit stl files. I downloaded from the internet mesh enabler, the installation went well but the menu does not appear, what should I do? thanks to all byerci:)

hi to everyone, I wanted to ask you if you can edit a .stl file with solidworks. thanks to all

Good evening to all, I would like to ask you a question that I hope is banal! I scanned some parts of an object through a 3d scanner and got a set of files. I would like to create a set of these objects, i.e. to recompose them into one object (to understand how to do it with solidworks when...

Bye to all, I had from a 3d scan a cloud of points and would like to turn it if possible into stl and then into solid with nx is it possible? Thank you.

hi to everyone, I am new to this forum and it is the first time I write. I am performing a project, fluid dynamic simulations through a cfd on 3d models in stl of a swimmer's hand; the problem is that I have to perform calculations that include the area of the hand and I can't figure out how to...

Bye to all, at work I need to open stl, iges and prt files, containing 3d scans, very heavy (average 500mb). Can you recommend a 3d freeware viewer that also allows measurements? I have no experience in this regard and I have no cad modeler available:( Moreover, not having a workstation, do...

hi, during the conversion to .stl creo format gives me the error "impossible to triangulate the part ....the output is interrupted". Since I do not know a way, in I create 2, to identify the area that has triangular problems (in fact nothing is highlighted) begins the odyssey to spulciate...