superficie

Hello, everyone. I am a master student of mechanical engineering. [SOLIDWORKS] At the moment I have to carry out a project that concerns the redesign of the armrest of a seat for public transport on rubber. What I have to do is work on an imported file. the imported file consists of patches of...

Hello, could someone give me a hand in converting a solid honeycomb structure to the surface?(I attach photo) I look for some advice. I would like to get a surface as I later need to perform fem analysis. Thank you.

Bye to all, Does anyone know if inventor 2016 solved the big problem of giving a color to a single surface of a piece? Palo

Hello, I am coloring a frame (so all curved surfaces 3d) and I would like to know if it is possible and how to insert an image on its surface. thanks in advance :smile: ps. are the first weapons with solid edge...

Bye. I designed the surface of a trunk cone and I need to get the flat shape, as it happens in inventor with the sheets more or less. in the English version there is a command called "unfoldsurf" that serves this purpose, but in the Italian version I can't find it, can someone help me? :

Hi, guys. I have a request for you. I have catia v5 r20 and I am drawing a particular carter originating from a complex surface with thickness. Now I have a problem, I have to print the prototype in 3d via 3d-fdm printer but I do not want to print the full carter, but all drilled with holes with...

hi to everyone, I am new to this forum and it is the first time I write. I am performing a project, fluid dynamic simulations through a cfd on 3d models in stl of a swimmer's hand; the problem is that I have to perform calculations that include the area of the hand and I can't figure out how to...

Hello. I just can't create a solid from this surface. It is an offset surface of 2.5mm towards the inside and then closed with 2 "caps" at the ends.Annex. Can anyone help me? greetings

hello to all as from title I have some problem when I amount a .igs file in mastercam x4, in the sense that importing surfaces creates me "defects" in the joints between surfaces... . Now I was wondering if it was a matter of setting up imports and if I have to put my hands? thanks in advance Palo

Bye to all, I have a problem that I don't know how to solve, I can't find anywhere like this. It is a rectangular surface. on it I should apply a "pression" (better tangential effort) tangent to the surface itself, in the direction of one of the two sides of the rectangle. It is not over: this...

hello raga, I should perform a sweep with sform direction and give a law because the segment that flows along the guideline sweeps a certain alpha corner. the sweep is necessary because I will serve as a support surface to realize the filling of the terminal part of the rudder, which as you see...