sweep

Good evening, for a project we are developing, I would need to perform a sweep cut inside a body. "the tool" that must perform the cut is not cylindrical and I would have thought of using a solid sweep cut. to theIn the example that I reported, I should take the " parallelepipedo" with the...

Good morning. I should build a surface with two different profiles, which is guided by a curve and must be constant to a reference surface. Do you have ideas about how to do that? Thank you.

Good morning to all, I have a problem that I can't solve, maybe it's a setup to select or anything but I don't know how to help me :tongue: in a few words the helical sweep command gives me error if I create a section with a profile greater than the step. I better explain, if I want to create...

Good evening, everyone! I am trying to follow a tutorial ( https://www.youtube.com/watch?v=sdh_wjpwxoq ) to create a bulb. use sw 2012. Could you explain to me how to get the first 2 lines - a curve and a straight - that support the filament? the first is using the spline since it is curved...

Hello everyone, I'm a mechanical engineering student and I'm going to revert a coclee until I get a model I can use for simulations in my graduation.the coclea in question (photo), coupled with his twin (specular), takes the product from a line (right), separates it from the line and rototrasla...

hello raga, I should perform a sweep with sform direction and give a law because the segment that flows along the guideline sweeps a certain alpha corner. the sweep is necessary because I will serve as a support surface to realize the filling of the terminal part of the rudder, which as you see...