taglio

Good day to all, Having to make a tip for copper sheets I am looking for information on which is the best cutting angle to make the blade. It is about cutting small copper sheet width 100 mm thickness 0.5 mm. I have to make a tip like that of the plates, with a fixed blade below and a mobile...

Good evening, I ask for information to all. I create files on solidworks daily and recently I need to insert on the various sheets the article code, unfortunately it is a marking therefore not necessary to make an extruded cut, I need to make therefore a line "2d" without the laser making me a...

hello to everyone, I would need extra knowledge for designing rotary stems e roller portal in drawing them better. I would like to understand the creation (procedure and sequence processing) , it would be useful to have documents taken from correct sources and perhaps examples of technical...

Good morning to all, I ask kindly support for the sizing (approximate) of the diameter of the stem of the hydraulic cylinder represented in figure. basically the stem of an oleodynamic cylinder has a f force of 43'000n applied at the end and this cylinder passes through the hole of a fixed...

Good morning to all, I am paolo m. and is the first discussion I create even if I have been following for several years cad3d. I kindly ask you support for the sizing of a hammer mill that was commissioned for the company in which I work. I do not ask you to solve calculations (as precise data...

Good evening, for a project we are developing, I would need to perform a sweep cut inside a body. "the tool" that must perform the cut is not cylindrical and I would have thought of using a solid sweep cut. to theIn the example that I reported, I should take the " parallelepipedo" with the...