vincoli

Hello everyone! I write to you as until today I have never found the need to define attributes to create dynamic blocks, while instead I wanted to cite in creating a dynamic block for a cartilage, with all fields editable through attributes. but a problem arises: in the upper right corner, as...

Hello everyone, my problem is a little unusual. I would have the need to fix a spline that I generated by retracing the profile of an object formed by a polyline. otherwise I would have the need to convert a polyline to a unique item exactly identical. Thank you in advance. ps: control...

hello to all, I tried to create a mixed set of plates, plates and profiles. I have struggled to place them in the exact positions I wanted and then even more in wanting to move them (simulating a design phase where the odds are not definitive). the main difficulties I have encountered have been...

Bye to all, I would like to make in caia assembly a skel model of cardanic joint. the system consists of 3 parts: - input tree - cruise - exit tree all 3 are schematized with simple lines as in the attached image, as it is a skel model. I impose the bonds of coincidence of the 4 points of the...

Hello everyone, I am new to the forum, and I have a question perhaps of little interest to many, but for me it is becoming an obsession. in the realization of assemblies, I often need to move a component in the assembly area either vertically or horizontally (or in any case with a fixed...

Good evening to all, I am a university student of mechanical engineering. as part of a project I must carry out a fem analysis on a small motor shaft (diameter 8 mm). I wanted to know what the correct constraints are to be applied for static analysis. in fact I tried to bind the tree in various...

Hi. someone knows how to put constraints to make sure that example, two skates on a track are attached, but if I move a skate in one direction, the other moves on the opposite side, moving away? thanks and good work to all. Palo

Good morning. I'm new to the forum, in the company where I started working you use a lot of tebis software and I'm slowly learning to use it. I was wondering if you can insert custom constraints into the tebis (maybe via plugin) which will then be automatically set according to the case from...

Hi. . I have to do a set using the mirror function to repeat the same pieces (I can't use the series) using the mirror function the mirrored pieces do not "bear" the constraints placed on the original? otherwise I spend more time putting all the constraints I need.... alternative solutions? ...

Hello everyone I need to insert a part in a set with three constraints (as is typical) of which one (coupling angle) I would like to guide it from family table. I did a research but I couldn't find help. have any of you already faced the problem and know how to do it? thanks in advance and...

Hello everyone I need help: Did someone find a way to simulate a "shock"? There are 2 bodies a and b. the first is commanded by a levers system, while the second is bound by a spring and is free to move on skates ( straight). a is at a distance x from b and begins to move towards the latter. x...

Hello everyone, I just started using sw simulation 2014 and I have a problem (I believe banal) with the application of some constraints. . . in my case I have a structure composed of beams and pillars that the software considers as trave elements during the simulation phase (structure visible...

Hello everyone I am a biomedical engineering student, I am approaching with ansys 12 apdl . I noticed that when I go to bind wrapped there is the rot displacement and wrapped up by what it depends, someone can explain it to me?! !

Hello, guys. I have another doubt about the structure that I am making and that I will have to analyze in solidworks simulation.. .the structure I have to analyze is constituted by some parts that I have made separately. . Should constraints be specified during assembly (in assembly) or in the...

Bye to all, I am moving the first steps with inventor and I find myself in difficulty:confused:. I want to insert objects (ipt) into a set (iam) and place them in certain x,y positions but I don't understand how it can specify this position. in the specific now I want to place a cylinder on a...