11g 5/8 thread on inventor 2012

[Alby189]

Bye to all,
I need to draw threads as in object, i.e. 11g 5/8 in ivnentor 2012.
In the thread mask I have the families you see in the annex, in those I can't find what I do to my case.
making a relief in the cap that I have as sample, the diameter of hazelnut (of the inner hole) is about 40mm, and the value 11g 5/8 I was supplied by the supplier of the commercial plug.

You know where I can find that thread?
Thank you! !

 

[Tarkus]

Bye to all,
I need to draw threads as in object, i.e. 11g 5/8 in ivnentor 2012.
In the thread mask I have the families you see in the annex, in those I can't find what I do to my case.
making a relief in the cap that I have as sample, the diameter of hazelnut (of the inner hole) is about 40mm, and the value 11g 5/8 I was supplied by the supplier of the commercial plug.

You know where I can find that thread?
Thank you! !

If you don't find it, it's because it's not part of any rule, or it's not covered by our good inventor programmers.
you have to create it by editing the trehad.xls file that is located, if I don't remember badly in the given design folder.
do some research on the forum,you should go out something,any year ago I had to do threads 525x6, and I had to edit the file...
Anyway thinking about all those ad hoc threads that you do in the backroom, a "user thread" would not be to throw away...:smile:

 

[Alby189]

Thanks tarkus! I feared your answer.. .
before opening this discussion I spulved all the forum! including that part where you asked for 525x6 thread.. but I hoped I didn't have to edit trehad.xls and find the right command.
Thanks anyway! Now I'll see what to do!