David89
Guest
Hello everyone,
I have to optimize the geometry of a component by reducing the mass as much as possible, I would like to use workbench, I have seen several tutorials describing how to create the doe and get the best combination of parameters (lengths, heights, diameters, etc.) that meet the various objective functions. my problem is that, importing geometry into the workbench (file.iges), the geometry is constituted by a single solid, I can not view the sketches and therefore the various sizes of sides diameter fittings etc, and I can not create my set of design parameters. Can anyone help me?
Thank you in advance.
I have to optimize the geometry of a component by reducing the mass as much as possible, I would like to use workbench, I have seen several tutorials describing how to create the doe and get the best combination of parameters (lengths, heights, diameters, etc.) that meet the various objective functions. my problem is that, importing geometry into the workbench (file.iges), the geometry is constituted by a single solid, I can not view the sketches and therefore the various sizes of sides diameter fittings etc, and I can not create my set of design parameters. Can anyone help me?
Thank you in advance.