tortuga
Guest
Hello everyone,
I press that what I am doing is only for personal experience.
long ago I tried with fluent and managed to enable the mesh interface menu on fluent setup, I think defining mesh edges. Now I don't remember where I have to go to act specifically, or on the definition of edges? Can you help me?
You will ask what I have to do.. Right. considered as if I had to rotate a parallelepiped at 40 rpm in a hypothetical wind tunnel where the wind speed is 30m/s.all this to see the change of pressure, turbulence on the parallelepiped to its rotation.
suggestions?
thanks for any response.
I press that what I am doing is only for personal experience.
long ago I tried with fluent and managed to enable the mesh interface menu on fluent setup, I think defining mesh edges. Now I don't remember where I have to go to act specifically, or on the definition of edges? Can you help me?
You will ask what I have to do.. Right. considered as if I had to rotate a parallelepiped at 40 rpm in a hypothetical wind tunnel where the wind speed is 30m/s.all this to see the change of pressure, turbulence on the parallelepiped to its rotation.
suggestions?
thanks for any response.