apdl how to run a for cycle to connect different knots.

[NGC]

Good morning.

I need to connect a knot to which I attach a force to a surface that has several knots through rigid connections. how can I implement a cycle for so that it automatically does it on ansys apdl?

My goal is to distribute a moment on an irregular surface consisting of sup154 elements.

Thanks

 

[volaff]

going to memory you should know what the elements (and knots) you want to connect.

 

[F_Ingrasciotta]

Hi.
to connect a node (master) to other nodes (slave) I would tell you to use the cerig command.
regarding the selection of slave nodes you can lean on a simple nsel.

the two commands you could insert them into a cycle for though without other indications it is difficult to try a solution in image.