apply moment at a point

[Raffaele_M]

Hello everyone, I put my case in ansys workbench. I have two supports of a motor and should see how the attacks of these supports react (6 holes each) because of the engine drive couple. I would not like to model the geometry of the engine base, how can I do to apply a moment on a board? I tried, but he gave me "invalid volume." and how can I bind these holes to the centre of the engine?

Thank you.

 

[narra12]

If it says "invalid volume" you might have some problem with the cad model, what program did you use to draw geometry?

 

[Raffaele_M]

narrates the model is in catia. I think I have solved the beam lines. If I connect this axis to the support by inserting a joint on the upper and lower surface of the hole and I connect each joint to the beam on which I applied the moment is right according to you? Thank you.