change scale on view in section.

[New Rider]

Hi.

I ran a view in a witness section. I created the cutting plan and then its section.
I need to aumerate the scale precisely of the section but the command scales in the propitiation of the section is inactive.You have some suggestions.
I also wanted to understand how to automatically mark a set after I've already placed the distinction.
in any way support solidedge very bad and fast.

Thank you.

 

[Be_on_edge]

Hi.
when the views are "allined" have the same scale; in order to have a different scale you will need:
- Right-click on the view
- uncheck "maintain alignment"
- vary the scale of the view
- show the scale of the view (recommended)

I point out that this is outside the design rules, which instead contemplate the use of "details" to highlight details in a larger scale

 

[New Rider]

Hi.
when the views are "allined" have the same scale; in order to have a different scale you will need:
- Right-click on the view
- uncheck "maintain alignment"
- vary the scale of the view
- show the scale of the view (recommended)

I point out that this is outside the design rules, which instead contemplate the use of "details" to highlight details in a larger scale

thanks be on edge. regarding the bubble after placing the table?
In practice I positioned the table but I didn't activate the ''automatic hose' check as I can fix? Thank you.

 

[Be_on_edge]

thanks be on edge. regarding the bubble after placing the table?
In practice I positioned the table but I didn't activate the ''automatic hose' check as I can fix? Thank you.

use the same command you used to create the table by activating the ball creation and deactivating the table creation.

If you delete the table and I'd regrow it all together, you put the same time