Igor Novelli
Guest
Good morning, everyone!
in creo parametric, I have to create a relationship or setting that allows me to assign every component of my explosion to a single layer. In addition, I would like there to be a correspondence between the layers and the values shown as an index in my table (rpt.index). Therefore, to exemplify, if a screw has the catalog data 28, I would like it to occupy the "level 28".
the problem is that in I create I don't find the numbered layers as in autocad, for example, so I don't even know where to start to create that match. Does anyone know?
Thank you in advance!
in creo parametric, I have to create a relationship or setting that allows me to assign every component of my explosion to a single layer. In addition, I would like there to be a correspondence between the layers and the values shown as an index in my table (rpt.index). Therefore, to exemplify, if a screw has the catalog data 28, I would like it to occupy the "level 28".
the problem is that in I create I don't find the numbered layers as in autocad, for example, so I don't even know where to start to create that match. Does anyone know?
Thank you in advance!