cubic elements

[gtsolid]

Good morning to all
I would, in the workbench, impose cubic elements instead of triangular ones in the mesh. How can I do that?

 

[stefano.garbin]

hexaedral elements are applicable to "mapable" geometries.
your geometry must be divided into parallelepipeds (even with curved sides), then you can make mesh hexaedriche.
in the case of generic geometries the only type of mesh that works "always" (that is, it can go automatically) is that to tetrahedra.

in any case studies well the guide of ansys, in particular the chapter dedicated to mesh.
on the customer portal ansys there are many downloadable documents for registered users.