Pilu89
Guest
Hello everyone! I am brand new to the forum and I apologize if there is already such a discussion but I couldn't find it.
I have the need to create explosions from rows of proes and then make table harvests for dexteristics.
in general use inventor. for what I read (and then found), in relation to what I should do, especially for explosions, inventor is better than (buon)old offspring. my problem (one of the many) is the import of the rows of proes in inventor. opening it in inventor in the original format (.asm), the parts of the contained center are staggered (of the 19" washers in practice
). Also when I go to create the ".ipn" file for the explosive invetor, which I would then open in the table, the constraints between the parts are not recognized, so it does not create the automatic explosion.
when it comes to the problem of the parts of the contained center, I read about the possibility of converting to ".igs" and pointing to inventor the geometries but I couldn't do it. but I don't know what to do.
thanks already from now on
I have the need to create explosions from rows of proes and then make table harvests for dexteristics.
in general use inventor. for what I read (and then found), in relation to what I should do, especially for explosions, inventor is better than (buon)old offspring. my problem (one of the many) is the import of the rows of proes in inventor. opening it in inventor in the original format (.asm), the parts of the contained center are staggered (of the 19" washers in practice
). Also when I go to create the ".ipn" file for the explosive invetor, which I would then open in the table, the constraints between the parts are not recognized, so it does not create the automatic explosion.when it comes to the problem of the parts of the contained center, I read about the possibility of converting to ".igs" and pointing to inventor the geometries but I couldn't do it. but I don't know what to do.
thanks already from now on