paolina
Guest
Good evening to all
I am doing research on a 3d nozzle, I created a face (in 2d) for the calm chamber, one for the nozzle and one for the exit duct to study the limit layer; the question is the following: in the calm chamber and in the nozzle I interrupted less accurate then with a less dense mesh on the walls in the exit duct I have to have at least double the points... If you like?
Thank you.
:smile:
I am doing research on a 3d nozzle, I created a face (in 2d) for the calm chamber, one for the nozzle and one for the exit duct to study the limit layer; the question is the following: in the calm chamber and in the nozzle I interrupted less accurate then with a less dense mesh on the walls in the exit duct I have to have at least double the points... If you like?
Thank you.
:smile: