giovannima
Guest
Hello, it's young and I'm using ansys 15 for thesis.
during the non-linear analysis of a component I observe that during the analysis the software does not converge to the solution or better on a time =100 arrived at the time=67 the program does not go ahead, the itera program without converging.
What can that be? ? tips are well accepted.thanks
during the non-linear analysis of a component I observe that during the analysis the software does not converge to the solution or better on a time =100 arrived at the time=67 the program does not go ahead, the itera program without converging.
What can that be? ? tips are well accepted.thanks