problem quotas during table setting

[Bonfi]

Good morning, everyone.
Needed to quote the distance between the two black arrows, but the altitude must indicate the distance not vertical, but parallel to the straight indicated by the red arrow, is there a way to do all this?
Thank you very much to all in advance.

 

[Catafratto]

I would do a sketch on the view, I would design two hyphens (red ones) as you would with autocad and I would quote those

 

[stefanobruno]

touch the horizontal line where you have the black arrow down, dx key, intersection selections, touch the tilted line that refers to direction, repeat the procedure for the opposite side where you have the black arrow up.

 

[Bonfi]

touch the horizontal line where you have the black arrow down, dx key, intersection selections, touch the tilted line that refers to direction, repeat the procedure for the opposite side where you have the black arrow up.

Thank you very much, just the solution I was looking for! :

 

[Zac69]

I don't want to argue, be clear, I remember this post and the correct answer of stefanobruno that has just preceded me.
but: 20 days to quote and say it works?
Good day

 

[Bonfi]

I don't want to argue, be clear, I remember this post and the correct answer of stefanobruno that has just preceded me.
but: 20 days to quote and say it works?
Good day

Good morning, I know, I actually responded a little late, I was just lying, I apologize to everyone for the discomfort.
Have a good day.

 

[Zac69]

Good morning, I know, I actually responded a little late, I was just lying, I apologize to everyone for the discomfort.
Have a good day.

You don't have to apologize and, I repeat, it wasn't about to argue, it was just a reflection. If I ask a question is why I need it. If I find an answer, I'll try it right away. then (even after finishing what I was doing) I write whether it worked or not. also because those who answer would like to know whether he wrote a good suggestion or not. and so you grow together.
Good day to you too