solidworks90
Guest
Good morning to all,
looking at the videos of presentation of sw 2016, it is noted that while you make cuts, the display of the material where you intervene changes (with a rougher look just like a real processing). I attach the link of the video, I would like to know how to set sw to get a graphics like this.
Thank you very much in advance.
http://www.solidworks.it/launch/#12498 (you find the part I'm interested in by minute 3)
looking at the videos of presentation of sw 2016, it is noted that while you make cuts, the display of the material where you intervene changes (with a rougher look just like a real processing). I attach the link of the video, I would like to know how to set sw to get a graphics like this.
Thank you very much in advance.
http://www.solidworks.it/launch/#12498 (you find the part I'm interested in by minute 3)