table folds

[cccicccio]

I just started working with the sheets and until today I created the fold tables with paper and pen.
only now I realized that if it offers the possibility to create these tables.
I tried to make it, but I can't.
I create the table but then I can't put it in the draft.
Could any of you explain the step-by-step procedure to succeed in my intent?
Thank you.

 

[gerod]

You have to create a table in what sense?
If you mean the table like that of the holes... I would say if you give an eye to the help there is explained well.
I don't have any pressure on you, so I can't help you anymore.
I still don't use this method because it does all the bending machine software
Hi.

 

[cccicccio]

cecare in the software help was the first thing I did.
I have just approached this world of sheet metal processing and so a little at a time try to learn more and more.
in if there is in the tool menu insert table folds where you can change the fold order and see the various informations of the individual folds type radius and angle.