giulio1993
Guest
Good evening, everyone. I have a problem with topological optimization of a head of a mono suspension for motorcycle. After uploading the model and running the simulation I go to do topological optimization but I would like certain areas (for example the area surrounding the eyelet hole) not to be touched by optimization and I don't know how to do it! "optimization region" I see as below "exclusion region" the possibility of selecting or geometries or, the boundary conditions previously fixed (immagino reveres to constraints and imposed loads right???) and named selection. I would like to have my eyelet and an area of tot mm around it unchanged. the eyepiece already does not deform/optimize because it is bound. If I wasn't clear, please excuse me. if you need some other info are at your disposal.
Thank you for your attention
Thank you for your attention