wjmat
Guest
Hello
I tried to find somewhere but I didn't find a solution to the problem.
for processing needs with selca post processors and also to simplify some 2d profiles I would like to know if there is a command that allows the division of spline or nurbs in lines and arches by setting a shock tolerance from the origin curve.
Thank you.
Hi.
I tried to find somewhere but I didn't find a solution to the problem.
for processing needs with selca post processors and also to simplify some 2d profiles I would like to know if there is a command that allows the division of spline or nurbs in lines and arches by setting a shock tolerance from the origin curve.
Thank you.
Hi.