drilling pattern, it is possible in toolbox

[skia51]

Hello everyone, answer me with another question,
I am now working with beams that are then bolted with perforated plates. the plates are specific for the beams, in the sense thata he200 will have its perforated connecting plates for the soul and for the wings, which will be different for the other beams he. Now I have to draw the puncture pattern on the ends of the beams by making the first hole and then using the repetition functions, is it not possible, with only one command, to already make all the holes previewed for that beam? I would like in practice a comado toolbox where I choose the drilling for the type of beam, if it is puncture for the soul or wings, I choose the reference point for the drilling and sws returns the beam with the pattern already made-
I hope I've been clear.
Thank you all.
p.s. I read the discussion about how to customize the toolboxes but the example allows to manage a single hole not a pattern.

Thanks again

 

[MassiVonWeizen]

like what you find in library address of the project\solidworks version\design library\features\metric\hole patternsyou can see opening the ctrl+f1 bread task

project library address can be found under file options>positions

 

[skia51]

like what you find in library address of the project\solidworks version\design library\features\metric\hole patternsyou can see opening the ctrl+f1 bread task

project library address can be found under file options>positions

Thank you! !
Yes something like that, I never used this command and I didn't know the existence of it, I'll see how to use it if I had any problems allow me to break your boxes a bit
Thank you.