Alberto1961
Guest
politely how do you do with inventor to make a box edged in sheet metal where the edges superior to and b are different? Thank you.
stefanobruno
Guest
A hand scarab?
Marco F inox
Guest
even to...mbrosio and b...isio are different, but how?
Cast16
Guest
Something like that?
Alberto1961
Guest
esatto ma in pi
Sorry, but yesterday I couldn't put the sketch in. in practice when I make the second bend at 90° a and b but of different measures I can not while with equal measures (at 45°) I can.....
Attachments
Cast16
Guest
What do you mean, "more"?
The video I sent you seems like the solution to your question.
Alberto1961
Guest
I'm sorry, but I got the incomplete answer. Anyway, if you look at the sketch I sent you, you know, thank you.
Peppe
Guest
create first the flap a or b (such as stretch width use all edge)
then create the other flap with different size than the previous one and as fold stretches use offset (as offset measure must be higher than the previous flap width)
finally angle joint to close the folds on both sides
then create the other flap with different size than the previous one and as fold stretches use offset (as offset measure must be higher than the previous flap width)finally angle joint to close the folds on both sidesAlberto1961
Guest
Thank you very much, that's what I was looking for, thank you again
Matteo Cappelli dis.CAD
Guest
Good morning
In addition, if you select all edges at the same time, you get the automatic angle joint bevel (of course all sides with the same length)
Good job
In addition, if you select all edges at the same time, you get the automatic angle joint bevel (of course all sides with the same length)
Good job