assembly and animation cross of mortar

[umberto.filippo]

hello to all today checking a project of my brother in inventor of the mortar cross I noticed that he can't turn well I wanted to ask you always if you can what design defect there is thanks to all

 

[eugenesis]

What do you mean "turn well"?

 

[Blacklight]

Hi.

I tried to assemble and to this end all right, but the animation I can't do it, neither with "contact group" nor with a movement bond (in fact, a continuous transmission relationship is assigned, and not an angle click as required).
My competence stops here, I pass to the most experienced.. .

 

[eugenesis]

I think you've got the size of the rollercoaster, which is the same as that of the rod.
If you give some light-tolerance, then you put contact group, surely turn
without problems, I used it in the past on sample files downloaded from cds attached to paper manuals ..

 

[Ilario]

I think it depends on how you bound him.
I managed to animate it perfectly. I would post the file but you have a version of inventor below my so you wouldn't be able to open it.
How exactly did you bind him and what did you animate?

I only added the video to show you that it is possible with the measurements and pieces you created without changing size. the rest make the constraints and the contact group.