cad configuration manger. da ansys wb14 a creo parametric 2.0

[enrico1979]

Hey, everybody.

I would like to configure cad software in ansys wb14, or better I would like to configure creo parametric 2.0 (I don't know if it is supported and so if it is necessary to return to parametric 1.0).
cmq if I have to configure proe wf5 there are no problems, i.e. in the drop-down menus of wf5 at the top I get the one related to ansys and therefore everything ok.
in parametric, which has a different interface without the drop-down menus present instead in pro and, once configured the cad configuration menager, I do not know where to find the necessary commands to control (increo paramentric) ansys.

Can anyone help me? ? ?

thank you in advance, hoping that my question has been understood (I am at work and I have no time to improve its shape, so excuse me)

 

[eih64]

ad help ansys 14 : creo parametric 1 is supported does not talk about the 2.

Ask technical support.
Good job

 

[eih64]

See Annex :wink:

 

[stefano.garbin]

with a little patience will also exit integration with creo 2.

 

[enrico1979]

Bye, guys and thank you.

My problem is that I can't even in creo 1.0 find where the command is located to be able to launch inside parametric, ansys, unlike what I can do with simplicity with pro and wf5 (where the special drop-down menu appears at the top).
I'm going crazy and I'd need it because in this way I could create a parametric study that I need at work (wf5 there is I have it in my computer and nn in my work), which through the usual passage through file step, iges or etc does not allow me.

please and thank you the same.

 

[eih64]

you don't see it because the plug-in is probably not installed.
then take the installation cd and proceed to the installation of the above.
then go to the cad configuration manager ... otherwise call the technical support that will help you in the installation. . .
Good job