catia sheetmetal-problem thick sheet metal

[gemini179]

Good morning.
Trying to change thickness to the sheet profile the program goes to stall. Is that a problem that happens to you, too?
If you could suggest an alternative to what I do?
My proceedings:
-open the part in the environment "generative sheetmetal design
-click on "sheetmetal parameters"(as in photo)
at this point it would be enough to change the parameters, but the program will be stacked.
Thank you for your answers

 

[falonef]

Hi.

try to change thickness not in folded but flat mode.
I hope you understand what I mean.

 

[gemini179]

Hi.

try to change thickness not in folded but flat mode.
I hope you understand what I mean.

Hi.
I think you mean in "developing piano" mode, I just tried and crashes anyway

 

[falonef]

I mean exactly that way.

try to create a new part without bending.

then try to change the thickness.

so you can isolate the problem with or without bending, holes etc.

 

[gemini179]

I mean exactly that way.

try to create a new part without bending.

then try to change the thickness.

so you can isolate the problem with or without bending, holes etc.

the only way to change is to delete the sheet parameters, and this means to have only the starting sketch. therefore, while having a simple wall, the problem still arises. as starting from zero coast of time, I would only want to change the thickness. In fact, the software crashes on this operation doesn't always happen, but when it happens, it's a nice bitch.

 

[falonef]

But did you activate the smd license?
Are you in the sheetmetal working environment when you try to change the thickness?

 

[gemini179]

But did you activate the smd license?
Are you in the sheetmetal working environment when you try to change the thickness?

I have to check on the activation of the smd module, but I think it's active,I can't do any smd operation.
Yes, they are in the sheetmetal environment when I try to change the parameters.