ijk
Guest
Hello everyone, I'm learning how to use alias very little and I have some difficulty in understanding a result of the extrude command. I attach an image to explain well the purely didactic question. with extrude I follow a sweep of a circle r 10 (profile curve) placed on the zx plane (by where I then put the tangency locator), along a circle arc of r 300 (guide curve) placed on the xy plane. I created only half of the sweep and the thing that surprises me is that when I generate symmetric geometry compared to the zx plane the two surfaces are not in tangence between them (as seen from the locator). the error even if the least leaves me perplexed. the command settings used are on the right of the image, the small circle pivot is in its center and that of the guide arc in absolute origin. thanks to those who want to intervene. Say hi.
