connection beams on multiple edges

[Leroi]

I tried to find the solution to this problem but with little success. If there is already, please redirect me to that discussion.
I'm trying to make a carcass of a reducer with two side covers. These circular rounds are not protruding but ''inglobed'' on the side face of the carcass. I wanted to know if it was possible to collect only the edges of the lids that are dirty outside.
with the fitting function, the program connects the entire circular profile of the cover, while I would like it to be performed only on the arc of interest.

 

[eboss]

you should at least post some pictures or part :wink:

 

[Leroi]

You're perfectly right. I would only like to collect blue color profile

 

[MFT]

and you can't do it with the cutting command in revolution giving it the starting and arrival point that interest you?

 

[eboss]

View attachment 33752You're perfectly right. I would only like to collect blue color profile

Now seeing the part would be better, it seems to me a multibodies the carcass of the reducer where you would like to make the radiation, so you could take into account using the sweeping function that follows the sketch path selected in the image:wink:.

 

[Leroi]

I didn't think about it. Thank you very much

 

[Leroi]

I know it's not the right discussion to ask, but, without placing the image, do you know how I do to remove the circles of the threads that are seen in the transparent assemblies (see picture above) ?

 

[eboss]

with view hide all annotations you should get what you want.

 

[Leroi]

Perfect! Thanks again!