gliavanza
Guest
Hello, guys.
as from title, I am using rough contacts in ansys workbench.
the contact type is similar to bonded up to a certain value of the load, after which the contact breaks.
I need to apply it between two different material blocks, as if they were attacked by a glue, and I can set different contact breaking load values for different cases.
I can't find where to set the rough contact breaking load anywhere.
Did any of you guys work with us yet?
greetings and thanks in advance
as from title, I am using rough contacts in ansys workbench.
the contact type is similar to bonded up to a certain value of the load, after which the contact breaks.
I need to apply it between two different material blocks, as if they were attacked by a glue, and I can set different contact breaking load values for different cases.
I can't find where to set the rough contact breaking load anywhere.
Did any of you guys work with us yet?
greetings and thanks in advance