dilemma on initial setting vault

[windreef]

Good morning,
I am implementing vault (basic) to inventor. being a free professional then managing more customers, I thought I would create more vaults, (one per customer) because in the remote case of having two files with the same name for more customers, vault would not allow it. It is true that it is a remote case, but possible. and then sincerely I liked to share a customer from the other to not risk getting confused.
my doubt is about the libraries and content center. I want to always use the same, being commercial components are not connected to any customer and they are ok for everyone, but I don't know if setting the same center content for multiple vaults goes in confusion and generates long-term problems going

thanks for the advice
Hi.

 

[Onda]

use only one volt, place a code on each filename, which identifies the customer in a unique way. with multiple vaults you complicate your life in no need.

 

[windreef]

use only one volt, place a code on each filename, which identifies the customer in a unique way. with multiple vaults you complicate your life in no need.

thank you so much, less bad that you recommended me for a single vault, I was looking for the unique content center speech for multiple vaults, you can do but it is not so immediate, with only one vault the problem does not exist. I'll split clients into folders. I don't see any contraindications. and anyway, you're right in putting a prefix that identifies the customer, even in the case of multiple vaults, if then I find a file knowing at the flight to those who belong is fundamental, otherwise I'd go a little further.

Thanks again
Hi.

 

[batleo]

Hi.
I have used vault for years, but if I'm not mistaken you can have files with the same name, just change the path, I imagine that having multiple customers you will have different folders of destination, different if you want to use it as a library component.