Sifeld
Guest
Hello everyone! I am new to the forum and I write to receive help about a model that I am creating with solid edge. I press that in the past I have "studied" this program, but over the years I have forgotten all or almost the basics of design.
My problem is that I can't make any protusions on a circumference.
as seen from the image I would like to replicate the tab along the whole circumference, but if I try to use a trivial copy paste this is placed on the circumference taking as reference the base of the element of origin, going here in the same direction of the source and not in that of the radius regarding the circumference.
At this point I ask you: is there a way to replicate the profusion equidistantly along the whole face?
My problem is that I can't make any protusions on a circumference.
as seen from the image I would like to replicate the tab along the whole circumference, but if I try to use a trivial copy paste this is placed on the circumference taking as reference the base of the element of origin, going here in the same direction of the source and not in that of the radius regarding the circumference.At this point I ask you: is there a way to replicate the profusion equidistantly along the whole face?