first steps with adina

[tidez]

download version 900 knots, I tried to do the tutorial 1 "deflection of a beam".
I don't understand why deformeds don't respect constraints, maybe shifts to knots will go well, but deformeds seem straight traits that connect knots...
Is there a way to view the elastic deformed of the beam?

 

[cacciatorino]

Maybe I say a stupid thing, but I don't think that the individual elements can be incurved as if they were "primary councils" (as the prof called them at the university) of the beam. at most can deform from parallelepipedo to parallelgramm. . . .

 

[tidez]

I'll explain better. the first tutorial proposes very simply a menola beam, modeled with a single beam element 1 m long framed to an extreme and subject to a concentrated load to the other extreme.
the deformed is practically a straight stretch from the first knot to the second knot, does not respect the disaster at the first extreme. . .
then the case of the same shelf subject to a uniformly distributed load (the same problem of displaying the deformed).
Finally, a double-built beam, subject to a distributed load (here the beam is modeled with two beam elements, if I understand correctly, and the deformed are two straight v sections, as if the beam was split in half :frown

 

[andrea-bio]

hi guys excuse me if I interfere in this discussion but I can't open my own (I don't find any way to insert new discussions)
Anyway. . .
I have a problem, I have implemented points to rebuild a curve (axis of my solid), I have inserted the lines between points to create the discretized curve, I have inserted the characteristics of the material (model-materials-manage materials definition-elastic-isotropic) and now I would like to associate this material to all lines that make up my body (set of lines)
How can I do that? ?
What did I do wrong? ? :
help meeee

thanks in advance :d

 

[Mike1967]

hi guys excuse me if I interfere in this discussion but I can't open my own (I don't find any way to insert new discussions)
Anyway. . .
I have a problem, I have implemented points to rebuild a curve (axis of my solid), I have inserted the lines between points to create the discretized curve, I have inserted the characteristics of the material (model-materials-manage materials definition-elastic-isotropic) and now I would like to associate this material to all lines that make up my body (set of lines)
How can I do that? ?
What did I do wrong? ? :
help meeee

thanks in advance :d

about inserting new discussions check to have the button highlighted in the image below.
I can't help you.