first steps

[mariano79]

Hi, I'm new, I looked in the forum but I found nothing to do with my case. I wanted to ask you if there is some solid edge manual in Italian that describes the features, and the potential of this software. For example, I don't know what sensors are for, and I'd like to learn how I can try a car I designed.

 

[Tequila]

Hi, I'm new, I looked in the forum but I found nothing to do with my case. I wanted to ask you if there is some solid edge manual in Italian that describes the features, and the potential of this software. For example, I don't know what sensors are for, and I'd like to learn how I can try a car I designed.

hi and welcome, solid edge manuals are not there, there is a small handbook inside the packs but nothing more in Italian. the best thing to do would be a course but if you don't have the chance I would recommend some English books that are more complete. the part of the sensors however I do not remember if it is treated. Hi.

 

[mariano79]

Thank you very much, unfortunately the company for which I work no longer has assistance. I can't make the tutorials work that make me mistake and so I'm in a total stop state. I can only create parts, assemble and put on the table. that is the minimum indispensable!!! I would like to know the program better so that I can make the most of it, I'm sure it has more potential than I use it for. the machines that design are quite complicated (up to about 3000 parts) and try interference, make adjustable pistons and much more would really help me.

 

[Tequila]

The only thing you can do at the moment is look at the online help (f1) of solid edge. commands are explained and what else. then if you have time, desire and money try to watch these books http://www.sheetmetalguy.com/solid-edge-books.htm e http://www.amazon.com/solid-edge-designers-sham-tickoo/dp/1932709363

 

[mariano79]

from what I see, I'm in English, and to tell the truth, the English and I have been fighting many years ago.
Thanks anyway.

 

[mariarossi]

Hi.
I'd like to ask for your help because it's been 10 years that I haven't used solid edge and I'm freaking out. I created a very banal extrusion and I can't understand how it changes once it was created....!!!! with solidworks, inventor,... just double click.... help!

 

[Tequila]

is welcome presentation before posting messages

 

[denisbike]

Hi.
I'd like to ask for your help because it's been 10 years that I haven't used solid edge and I'm freaking out. I created a very banal extrusion and I can't understand how it changes once it was created....!!!! with solidworks, inventor,... just double click.... help!

click with the dx button above the extrusion and click on change protusion or definition