engineerspeed
Guest
to all,
My name is Marco and I am new to this forum. :redface:
I write as I am at first with ansys and I am facing a fluent simulation of a frankis turbine. was created by me with the specifications provided by the teacher using a code written on matlab, exporting the clouds of points of the blades and creating coherent geometries with the initial data.
I tried to run some simulation with fluent by reading some tutorials. Basically, the flow is simulated throughout the volume in which I enclose the turbine (I used as an "enclosure" tool) and not only in the duct of the volute, blades and diffuser.
Could someone who has a fluent dimesticity give me some advice? or maybe someone who has had to face similar problems could answer me? I might be able to figure out where I'm wrong.
Thank you all in advance :biggrin:
a dear greeting
My name is Marco and I am new to this forum. :redface:
I write as I am at first with ansys and I am facing a fluent simulation of a frankis turbine. was created by me with the specifications provided by the teacher using a code written on matlab, exporting the clouds of points of the blades and creating coherent geometries with the initial data.
I tried to run some simulation with fluent by reading some tutorials. Basically, the flow is simulated throughout the volume in which I enclose the turbine (I used as an "enclosure" tool) and not only in the duct of the volute, blades and diffuser.
Could someone who has a fluent dimesticity give me some advice? or maybe someone who has had to face similar problems could answer me? I might be able to figure out where I'm wrong.
Thank you all in advance :biggrin:
a dear greeting