gestione mold tooling design

[Andrea94kt]

Good morning to all, I joined the forum to ask you information about Moldova tooling design.
In particular, I would like to know whether it was possible to enter details via mtd, not as "special new", but rather as "existing detail".
In this way, in the workbook, I will not have double files, example: screw_a_1, screw_a_2 etc, but only the "vite_a", inserted several times in the various product.

also can you change the icon on the tree, details inserted through mtd?
and last question, is it possible to "isolate" the elements inserted with the mtd, so as to make them equal to those inserted with the assembly design?
I hope I've been clear
Thank you!

 

[Vittorio]

you can
Just replace the screw you don't care.. with one you have previously entered
in this case the icon to you antipaths disappears.
for mtd icons it is not possible to change them if not as explained the line above