Francesco.Cavalliere
Guest
Hello, I should carry out a fluiddynamic simulation on a fin and the respective wheels behind.
the only problem is that in the workbench when I create my fluid domain I cannot intersect the wheels with said domain (in order to make the program understand that the wheels are tangent with the ground) but I have to leave a distance greater than 0 between the wheel and the ground.
if I put a very small distance between wheel and plot of the order of 10^-5 you think can go well or this can lead to mesh errors resulting in
loss of meaning of simulation???? How can I solve this? Thank you very much to all.
the only problem is that in the workbench when I create my fluid domain I cannot intersect the wheels with said domain (in order to make the program understand that the wheels are tangent with the ground) but I have to leave a distance greater than 0 between the wheel and the ground.
if I put a very small distance between wheel and plot of the order of 10^-5 you think can go well or this can lead to mesh errors resulting in
loss of meaning of simulation???? How can I solve this? Thank you very much to all.