insertion of a logo on a curved surface

[waltergonzato]

Good morning, use st6 and I would like to know how I can insert a logo on a curved surface. I think the solution is going to paint the feature with the logo itself, but I can't find where to insert the jpg file into the solid edge folder.
Can anyone help me?
Thank you.

 

[Be_on_edge]

if the logo is vector you can create a tangent sketch to the surface and then use the "scratch needle" command to spread it on the stem. from here you can do protrusion excavations or even just split the face.

if you only have a magnifying device then you have to create a "face style" and then use the "part painting" command to apply the style created on the affected face.

in the face style you have to go to the "finish" tab and from them you can select the image to use along with many other parameters to control the location and size.

Hi.