overmetal description on code nc

[gb13301]

Good evening, gentlemen!
are to ask if you think in featurecam you can insert in the nc codes the list of operations, in particular the overmetal left for roughing.
this only to be able to understand by going to the program the overmetal left during the processing without printing each time of the sheets unnecessarily.

Thank you

 

[mibit]

of the type:

N115 ( rough1 side 1 )
-- > n120 (overmetal = 1.25) <---
No 25 g0 g17 g94 g40
n130 t2 m6 ( fresa_candelam2100:reg 21.0 dia. )
n135 g54 g90 x-159,393 y78,388 s346 m3

Of course I do.

Bye.

 

[gb13301]

of the type:

N115 ( rough1 side 1 )
-- > n120 (overmetal = 1.25) <---
No 25 g0 g17 g94 g40
n130 t2 m6 ( fresa_candelam2100:reg 21.0 dia. )
n135 g54 g90 x-159,393 y78,388 s346 m3

Of course I do.

Bye.

first of all thank you for answering me....
Of course, that's what I'm looking for!
Can you tell me the description of the command to be placed on the post??
My owners bought a lathe with a fanuc control, you know where I can find one for fc?? After I would change according to our needs, it is for having a pre-complied base!!
Hello, thank you

 

[mibit]

Hi, gb.

Sorry but the poor reaction speed in responding to you, but I am always taken with the bombs and I have much less time than I would like to follow this forum.. .

to know what is the command of the post that sends out the message, sincerely I can't answer you, the posts I use them but I don't program them. If you need info and have the program at home, why don't you try to ask for delcam support, they know it for sure.

as for example post to be edited, some are uploaded during installation under the program folder (c:\programs\delcam\featurecam\posts). They're just basic examples, so be careful, but if you know how to schedule them there, you'll surely find something that's probably right for you.

Bye!

 

[gb13301]

Well, I tried to ask, but they answered me with so much mail that the job is long and to be able to do it you have to create a special macro, so that I let it go.
This is about post-loaded by default, there are, but do not control motorized .
something homesso together, so it should work.
I wait a few days for the machine to arrive, then I will check the correct operation.
Hello, thank you.

 

[Fabrizio Di Feo]

Hi.

it is very simple, click on the bottom right on the name of the post processor and go to "edit", then go to "configuration" and both on "start program" and on "change tool" go to create a line or add it to an existing line, I recommend before the command <eob>, the command <fini-allow> preceded by brackets or point and comma (depending on what numerical control you have) if you want it to be a comment. I hope I've been clear.

greetings</fini-allow></eob>

 

[Fabrizio Di Feo]

Example of change to post

Hi.